The Raspberry Pi Compute Module 4 comes in two main flavors: one with built-in eMMC storage, and one without it. If you opt for a Compute Module 4 with built-in eMMC storage, and you want to write a new OS image to the Compute Module, or manually edit files on the boot volume, you can do that just the same as you would a microSD card—but you need to first make the eMMC storage mountable on another computer.
This blog post shows how to mount the eMMC storage on another computer (in my case a Mac, but the process is very similar on Linux), and then how to flash a new OS image to it.
In addition to the tutorial below, I published a video version of this post covering installation and usage of
rpiboot for flashing the eMMC on Windows, Ubuntu, Raspberry Pi OS, or macOS:
Preparing the IO Board for mounting
Before you can set the eMMC storage into 'USB mass storage' mode, you have to put a jumper over the first set of pins on the 'J2' jumper—the jumper labeled "Fit jumper to disable eMMC boot":
Don't have a jumper? I bought a huge pack of jumpers years ago, and grabbed one from that bag. You could also pop any kind of conductor between the two pins, like a female-to-female jumper.
Then, plug a USB cable from your computer (in my case, my Mac—but it could be a Windows or Linux computer too) into the 'USB Slave' micro USB port on the IO Board, and plug in power:
The board will power on, and you'll see the red 'D1' LED turn on, but the Compute Module won't boot. The eMMC module should now be ready for the next step.
Using usbboot to mount the eMMC storage
The next step is to download the Raspberry Pi usbboot repository, install a required USB library on your computer, and build the
rpiboot executable, which you'll use to mount the storage on your computer. I did all of this in the Terminal application on my Mac.
First, make sure you have the
libusb library installed:
- On my Mac, I have Homebrew installed, so I ran:
brew install pkgconfig libusb
- On Linux (e.g. another Raspberry Pi), run:
sudo apt install libusb-1.0-0-dev
Second, clone the usbboot repository to your computer:
$ git clone --depth=1 https://github.com/raspberrypi/usbboot
cd into the
usbboot directory and build
$ cd usbboot
Now there should be an
rpiboot executable in the directory. To mount the eMMC storage, run:
$ sudo ./rpiboot
And a few seconds later, after it finishes doing its work, you should see the
boot volume mounted on your Mac (or on whatever Linux computer you're using). You might also notice the D2 LED lighting up; that means there is disk read/write activity on the eMMC.
Flashing Raspberry Pi OS onto the eMMC
At this point, the eMMC storage behaves just like a microSD card or USB drive that you plugged into your computer. Use an application like the Raspberry Pi Imager to flash Raspberry Pi OS (or any OS of your choosing) to the eMMC:
At this point, if you don't need to make any modifications to the contents of the
boot volume, you could disconnect the IO board (eject the
boot volume if it's still mounted!) USB slave port connection, disconnect power, then remove the eMMC Boot disable jumper on J2.
Then plug power back in, and the CM4 should now boot off it's (freshly-flashed) eMMC storage!
If you ever need to mount the
boot volume or re-flash the eMMC storage, just run
sudo ./rpiboot again.